Post by colawrence on Feb 14, 2013 11:42:44 GMT -5
Is there a way to constrain the movement of nodes or contours to a single direction, ie either up/down or left/right, but not both at the same time? In many programs, this is done by holding down shift, or CTRL, or some other key while mouse dragging, or arrow nudging.
Post by Allan Murray on Feb 15, 2013 3:59:23 GMT -5
You cannot constrain the mouse movements, but you can move in a single direction by using the cursor keys (press shift to move faster). Also you can use the move option from the point menu to enter an x or y offset manually.